51 13... Decal stripes on engine hood/bonnet
NOTE:
Notes and information on BONDING FILM/FOIL are an essential part of these instructions and must be followed without fail.
Stick on decal stripes using the wet bonding procedure.
Decal stripe position:
Mark centerline (1) of hood/bonnet at rear between spray nozzles and at front below MINI emblem.
Mark dimensions (A and B) on hood/bonnet.
COOPER/ONE:
A = 300 mm
B = 210 mm
COOPER S:
A = 380 mm
B = 250 mm
Stick on decal stripes.