65 83 570 Removing and installing/replacing CD drive for Car Communication Computer

Special tools required:

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

If necessary, cut through warranty seal.

Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).

Fig 1: Removing Car Communication Computer Cover Using Special Tool (64 1 020)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Feed CD drive (2) in direction of arrow out of Car Communication Computer (3) and set down.

Installation:

Ensure correct routing of cables.

Fig 2: Removing CD Drive Form Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove CD drive trim (2) in direction of arrow from CD drive (3).

Installation:

Ensure correct routing of cables.

Fig 3: Removing CD Drive Trim From CD Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through warranty seal (1) at marked point.

Release screw (2).

Lift side cover out of mounting (3) and carefully place to one side.

Fig 4: Identifying Warranty Seal, Screw And Mounting Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove CD drive.

Installation:

Ensure correct routing of cables.

Fig 5: Identifying CD Drive Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.