11 11 Engine block - table 2 of 2
TIGHTENING TORQUE SPECIFICATIONS - ENGINE BLOCK - TABLE 2 OF 2
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Main bearing screws, observe tightening specification. | N16 | M9x115 | Replace screws. | |
| Jointing torque Angle of rotation |
30 Nm 150 ° |
|||
| 2AZ Bedplate, observe tightening specification. | N16 | M6x35/M6x55 | Replace screws. Jointing torque |
9 Nm |
| 3AZ Screw plug, gear case upper section. | N16 | M22x1.5 | 35 Nm | |
| 4AZ Screw plug, gear case lower section. | N16 | M16x1.5 | Replace seal. | 32 Nm |
| 5AZ Oil spray nozzle to crankcase. | N16 | M10 | 20 Nm | |
| 6AZ Air conditioning compressor fixing. | N16 | M8 | 8 Nm | |
| 7AZ Retaining bolt (catalytic converter) to crankcase. | N16 | M8 | Bolt | 10 Nm |