Removal Of Side Wall Holder (Variant 2)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Release welded connection in area (1) and remove holder (2).

Fig 1: Removing Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part:

Fit in new part.

In area of adhesive surface (1), drill a 4.2 mm dia. bore hole (2) for blind rivet N3.

Remove new part and deburr holes.

IMPORTANT: Do not grind bonding surfaces down or off.

Fig 2: Identifying Location For Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Installation of side wall holder:

Clean all bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surface.

Install new part and rivet with blind rivet.