12 61 280 Removing and installing/replacing oil pressure sensor (N16)

Special tools required: 

• 11 7 020

Necessary preliminary tasks: 

• Switching off the ignition

Installation location: 

The oil pressure sensor is located in the oil filter housing.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Loosen screws.

Remove heat shield (1).

Unlock connector (1) and pull off.

Release the oil pressure sensor (2) with special tool 11 7 020 .

If necessary, release wiring harness (3) from oil filter housing and set it aside.

Installation note: 

• Renew the sealing ring.
• Tightening torque 12 61 1AZ .
• Check engine oil level, top up if necessary.

Assemble engine.