41 00... Safety At Work

WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

1.1 Working with aluminum dust:

Wear a fine dust mask.
E52 only: Use an explosion-proof extractor system .
Note national regulations.

1.2 Removing sealing materials

Hydrochloric acid is created when PVC sealing material is heated to temperatures in excess of 180 °C.
Remove PVC sealing material with a rotating wire brush only or heat material with a hot air blower to max. 180 °C and remove with a spatula.
Ensure that all enclosed areas are well ventilated or are provided with direct extractor facilities.

1.3 Arc welding and brazing:

IMPORTANT: The extremely bright arc during welding may cause serious injury to the eyes if appropriate protective measures are not taken.

Use a special welding screen for the relevant welding process (MAG or MIG).
Partition off the work bays with beam protection screens.
Use a welding-emissions extractor facility.
The welder must wear protective clothing and gloves which are suitable for welding (i.e. flameproof).
A fire extinguisher must be located within reach of the welding area.
Do not carry out any welding work in the proximity of a fuel tank e.g. when it is installed.
Note national regulations.

1.4 Working with adhesive products (adhesives, cleaning agents, primers etc.):

IMPORTANT: Handling adhesives can trigger off allergic skin and breathing reactions.

Do not eat, drink or smoke during this operation.
Avoid direct contact with eyes and skin.
Wear protective goggles, protective gloves and if necessary an apron.
Ensure that all enclosed areas are well ventilated or are provided with direct adhesive fume extractor facilities.
Work clothing which has been contaminated with adhesive or solvent must be changed immediately.
After finishing work, wash your hands and apply protective skin cream.
Always keep an eye bath on hand, change the water regularly (once a month).
Store adhesive products in a secure cabinet only.
Keep adhesive products away from naked flames and other ignition sources.
Protect adhesive products against strong heat sources and direct sunlight.
Note national regulations.

First Aid:

In the event of eye contact, flush immediately with running water for approx. 10-15 minutes and, if necessary, visit eye specialist.

In the event of skin contact and where applicable an allergic skin reaction, clean the affected areas immediately with soap and water and then apply silicone-free skin cream. If necessary, consult a doctor.

If an adhesive product is swallowed, rinse mouth/parts of mouth thoroughly with running water. Drink 1-2 glasses of water. Do not induce vomiting. Consult a doctor.

If adhesive fumes are inhaled, ensure a constant supply of fresh air, keep calm, keep respiratory tracts unobstructed and consult a doctor.