4161000 Removing And Installing Engine Compartment Lid

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Read general service information under BODY .

Necessary preliminary tasks:

Disconnect all cable plug connections

IMPORTANT: For the following work step, secure the engine hood against falling closed.

Disconnect gas-pressure damper from engine hood (1).

Loosen screws (2).

Release screws (3).

Tightening torque 41 61 1AZ .

NOTE: This work step must be carried out with a second person assisting.

Fig 1: Identifying Gas-Pressure Damper With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove hood lid.

Installation:

Install engine hood at screw locations to on hinge.

This dispenses with the need for adjustment after installation.

If this is not possible, ADJUST ENGINE HOOD .