Preparation Of New Part

Make severance cut on new carrier support part in accordance with severance cut on vehicle.

Open welded connections in area (1).

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) cut open engine support from opposite side and open welded connections.

In area (2) open welded connections from inside.

Fig 2: Identifying Engine Support Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust new parts to fit with alignment bracket or universal mount and secure.

In areas (1) to (3), set 6.8 mm dia. holes for blind rivets N1:

• Area (1): 3 holes

  Area (2): 8 holes

  Area (3): 6 holes

Installation: 

After adhesive has hardened, install 2 EMC SCREWS  in areas (1) and (2).

Fig 3: Identifying EMC Screws Area

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) and (2), set 6.8 mm dia. holes for blind rivets N1:

• Area (1): 3 holes

  Area (2): 2 holes

  Fig 4: Identifying Rivet Areas

  Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) and (2), set 6.8 mm dia. holes for blind rivets N1:

• Area (1): 1 hole

  Area (2): 7 holes

Installation: 

In area (3) 2 N5 punch rivets are used later.

Fig 5: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In area (1) set seven 6.8 mm dia. holes for blind rivets N1.

Installation: 

In area (2) 1 N5 punch rivet is used later.

Fig 6: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) to (4), set 6.8 mm dia. holes for blind rivets N1:

• Area (1): 5 holes

  Area (2): 2 holes

  Area (3): 1 hole

  Area (4): 9 holes

Installation: 

After adhesive has hardened install 2 EMC screws in areas (1) and (4).

Fig 7: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Set two 6.8 mm dia. holes for blind rivets N1 in area (1).

Remove all new parts and deburr holes.

Fig 8: Identifying Carrier Support Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.