LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2012 >> Cooper S, 2D Hatchback, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1921 (COLLISION - BODY PANEL REPAIR (E60) 528i, 528xi) >> Body Panel Repair General Information >> 4100... Notes On Adhesive K1 >> Do Not Use Any Compressed-Air-Operated Cartridge Guns >> Preparing The Glue Cartridge

Preparing The Glue Cartridge

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Opened glue cartridges may be used again before the expiry date as long as a new mixing tube is used.

The working temperature of glue cartridge must be at least 20°C.

Insert glue cartridge into cartridge gun, remove cap and allow both adhesive components to emerge. Strip adhesive components uniformly and attach mixing tube. Only use mixing tubes supplied with glue cartridge.

Approx. Allow approx. 10 cm of mixed adhesive to emerge and then apply the mixed adhesive first on one side of the bonding surface.

Pot life of mixed adhesive approx. 2 hours. A change of mixer is only necessary if over a period of 1 hour no material has flowed through the mixer.

scientia non olet · About LEMON Manuals