72 12 000 Removing and installing/replacing airbag module on passenger side

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Follow INSTRUCTIONS for unlocking and locking airbag plug connections
Remove GLOVEBOX with housing

Version (E60/E61) with front drinks holder:

Remove front outer cup holder CARRIER
Release front inner cup holder CARRIER

Inner carrier can only be removed together with airbag module.

Unfasten plug connection (1) and disconnect. Remove plug connection from holder (by turning).

IMPORTANT: Before releasing screws (3), secure airbag module (2) against falling out.

E63/ E64:

Release screws (3) and carefully feed out airbag module (2) towards bottom.

E60:

Release screws (3); if necessary, slide front inner cup holder carrier slightly to one side.

Carefully remove airbag module (2), if necessary with front inner cup holder carrier, towards bottom rear.

Fig 1: Identifying Plug Connection, Screws And Airbag Module

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When inserting airbag module (1) in channel (2), make sure channel rests all round airbag module. If necessary, pull channel apart at sides.

Replace screws.

Tightening torque 72 12 02AZ .

Fig 2: Identifying Airbag Module And Channel

Courtesy of BMW OF NORTH AMERICA, INC.