41 11 141 Replacing cover for left or right side member

WARNING: This page is about a different variant/trim than selected.

Read contents of BODY, GENERAL .

Following new body parts are required:

Fig 1: Identifying Outer Entrance

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Cut through outer plate only for following severance cuts.

Mark severance cuts in accordance with specified dimensions and cut.

Dimension a = approx.45 mm in front of

12x18 mm dia. elongated hole.

Dimension b = approx. 30 mm before 12 mm dia. bore hole.

Open welding spots in areas (1).

Installation note:

Weld in REINFORCEMENT PLATES at all severance cuts.

Fig 2: Identifying Cutting Dimensions On Outer Entrance

Courtesy of BMW OF NORTH AMERICA, INC.