51 24 300 Removing and installing or replacing left or right gas pressure spring for tailgate

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of injury!
Support tailgate in fully opened position with suitable device.

REMOVAL:

Make a written record of the alignment of the gas pressure support(s) before removing.

Slide retaining spring (1) to end of gas pressure spring (2) and lever out gas pressure spring (2) from holder.

Repeat procedure at other end of gas pressure spring (2) and remove gas pressure spring (2).

Fig 1: Sliding Retaining Spring To End Of Gas Pressure Spring

Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION:

Slide retaining spring (1) back into initial position.

Press gas pressure spring (2) on top and bottom end onto mountings on vehicle.

Gas pressure spring (2) must be felt to engage.

Fig 2: Pressing Gas Pressure Spring Onto Ball Pins

Courtesy of BMW OF NORTH AMERICA, INC.