51 23 265 Removing and installing/replacing left or right gas pressure spring for engine compartment lid

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of injury!
Use suitable tool to support bonnet in the fully opened position.

Removal:

Make a written record of the installation position of the gas pressure springs before removing.

If necessary, release cable clip on gas pressure spring (2).

Slide retaining spring (1) to end of gas pressure spring (2) and lift of gas pressure spring (2) from ball head.

Repeat procedure at other end of gas strut (2).

Fig 1: Sliding Retaining Spring To End Of Gas Pressure Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide retaining spring (1) back into initial position.

Press the gas pressure spring (2) onto the ball pins on the vehicle at the top and bottom end.

Gas pressure spring (2) must be felt to engage.

Fig 2: Pressing Gas Pressure Spring Onto Ball Pins

Courtesy of BMW OF NORTH AMERICA, INC.