51 31 045 Removing and installing/replacing trim on A-pillar, left or right

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release door seal in A-pillar area.

Release screws (1).

Release trim (2) at clips (3) and remove.

Installation:

If necessary, replace faulty clips (3).

Trim (2) must not be damaged, replace if necessary.

Fig 1: Identifying Trim, Clips And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, release clips (2) from A-pillar (1).

Seal (3) must not be damaged.

Fig 2: Identifying Clips, A-Pillar And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty nut inserts (1) on A-pillar (2).

Fig 3: Identifying A-Pillar And Nut Inserts

Courtesy of BMW OF NORTH AMERICA, INC.