41 34 037 Stripping operations - Replacing tail panel outer section (partial replacement)

WARNING: This page is about a different variant/trim than selected.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Disconnect negative battery cable (job number: 61 20 900)
Remove bumper trim (job number: 51 12 156)
Remove bumper support (job number: 51 12 050)
Remove tail panel cover at top (job number: 51 46 050)
Remove left and right rear wheel arch cover (51 71 041)
Lower rear exhaust system
Remove rear heat shield
Partially detach tailgate seal

Disconnect connector (1).

Release screws (2) and remove lock (3).

Tightening torque 51 24 1AZ .

Remove tailgate vents (4).

Release wiring harness from tail panel and luggage compartment floor.

Fig 1: Identifying Tailgate Vents And Screws

Courtesy of BMW OF NORTH AMERICA, INC.