LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2012 >> Cooper S, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 202 (Restraints - Repair (R59) -- Cooper_R59) >> Gas Generators, Airbag Modules (With Steering Wheel Airbag 3234) >> 72 12 050 Removing and installing/replacing side airbag in front seat

72 12 050 Removing and installing/replacing side airbag in front seat

WARNING: This page is about a different variant/trim than selected.
WARNING: Read and comply with SAFETY REGULATIONS  for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling may activate the pyrotechnical belt tensioner or side airbag and thereby cause injuries.

Switch off the ignition!

IMPORTANT: Operations on pyrotechnical devices may only be carried out by authorized experts.

Improper, unauthorized operations may result in serious dangers.

Unauthorized persons are strictly prohibited from performing any operations on this system. 

Necessary preliminary work: 

Cut open cable strap (1).

Unlock connector (2) and pull out of connector housing.

Installation note: 

Replace defective cable strap.

Connectors are coded against incorrect assembly.

Feed wiring harness out of holders (3).

Fig 1: Identifying Cable Strap, Connector And Holders
G04797775Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: Feed wiring harness carefully through seat and backrest frames owing to sharpness of edges.

Disengage seat cover welt from seat frame.

Unclip cable clip (1).

Feed wiring harness (2) out of seat and backrest frames.

Fig 2: Identifying Cable Clip And Wiring Harness
G04797776Courtesy of BMW OF NORTH AMERICA, INC.

Disengage welt on airbag side from backrest frame.

Release screw (1).

Installation note: 

Replace screw (1).

Tightening torque 72 12 06AZ .

Fig 3: Releasing Screw
G04797777Courtesy of BMW OF NORTH AMERICA, INC.

Disengage airbag module in cover pocket (2) from backrest frame.

Installation note: 

Cover pocket (2) must not be trapped between suspension hooks and backrest frame.

NOTE: Shown removed here for purposes of clarity.

Pull airbag module downwards out of cover pockets (1).

Installation note: 

Slide airbag module with suspension hooks up to opening in cover pocket.

Cover pocket (1) must not be damaged.

Fig 4: Locating Cover Pocket
G04797779Courtesy of BMW OF NORTH AMERICA, INC.