33 32 Trailing arms and struts
TIGHTENING TORQUE SPECIFICATIONS - TRAILING ARMS AND STRUTS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Upper wishbone to trailing arm | R60/R61 | M12 | Replace nut TIGHTEN IN NORMAL POSITION | 108 Nm |
| 2AZ Lower wishbone to trailing arm | R60/R61 | M12 | Bolt tightening sequence must be observed without fail. TIGHTEN IN NORMAL POSITION Initial torque release by Final torque |
50 Nm 120 ° 108 Nm |
| 3AZ Wishbone to rear axle support | R60/R61 | M12 | Replace nut TIGHTEN IN NORMAL POSITION | 100 Nm |
| 4AZ Holder, trailing arm to trailing arm | R60/R61 | M14 | Jointing torque and angle of rotation must be observed without fail. TIGHTEN IN NORMAL POSITION Jointing torque Angle of rotation |
140 Nm 90 ° |
| 5AZ Trailing arm holder to body | R60/R61 | M12 | 108 Nm |