LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2012 >> Cooper Countryman, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 744 (Maintenance And General Information - Repair Instructions - Cooper (R50) , Cooper S (R53) & Convertible (R52)) >> Maintenance & General Information >> 00 .. ... Symbols used and information in repair instructions

00 .. ... Symbols used and information in repair instructions

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Precautionary rules and measures which protect mechanics and other personnel against injury (including life-threatening injuries).

Example: 

WARNING: Danger of scalding! Only perform this work after engine has cooled down.
IMPORTANT: Specific instructions and precautionary measures which prevent damage to the vehicle or to vehicle parts. Failure to comply with the above will invalidate any warranty claims. The caution symbol is used in all repair instructions. However, use of the warning word "Caution!" is not binding in every case. The notes, instructions and precautionary measures mentioned above retain their validity.
NOTE: Particular information on improved procedures for operation, testing, adjustment and upkeep. Also indicates the end of a repair section.

Recycling: 

Observe country-specific waste-disposal regulations

General Information: 

Refers to other instructions: E.g.:

Further instructions: refer to operating instructions for tire balancing machine.

Replacement: 

Carry out programming/coding.

NOTE: Many electronic control units must be programmed/coded (e.g. when replaced).
NOTE:
  • Connect BMW diagnosis system.
IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).
NOTE: Electronic control units and other electronic components - if handled incorrectly - can be damaged or destroyed by electrostatic discharge.