51 47 491 Removing And Installing/Replacing Rear Underbody Protection

WARNING: This page is about a different car, the 2005 BMW 760Li, 2004 BMW 760i, 2004 BMW 760Li, and 2003 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Underbody Protection, Petrol/Gasoline Engines

Release screws (1).

Remove underbody protection (2) towards rear.

Installation:

Center underbody protection (2) and tighten down screws (1).

Fig 1: Identifying Screws For Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Remove heat shield (2).

Fig 2: View Of Heat Shield And Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Underbody Protection, Diesel Engines:

Release screws (1 to 3).

Remove underbody protection (4) towards rear.

Installation:

Center underbody protection (4) and tighten down screws (1 to 3).

Fig 3: Locating Underbody Protection Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.