41 62 007 Removing And Installing Rear Lid Lower Section
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Read contents of BODY, GENERAL .
Necessary preliminary tasks:
- Disconnect all plug and socket cable connections on rear lid bottom section.
Operation is described on the left side. Right side identical.
Pull wiring harness (1) out of tailgate lower section.
Release screws (2) and remove tailgate lower section with second person.
Tightening torque 41 62 4AZ .
Installation note:
Install tailgate at screw locations on hinge. This dispenses with the need for adjustment after installation.
If necessary, adjust REAR TRUNK LID .
If reversing camera optional equipment installed
Calibrate REVERSING CAMERA .