72 12 000 Removing and installing/replacing airbag module on passenger side

WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe safety regulations for handling airbag modules and pyrotechnical seatbelt tensioners.

Incorrect handling can activate airbag and cause injury.

Follow instructions for disconnecting and connecting battery!

Disconnect battery negative lead .

Remove glovebox .

Version with CD changer:

Remove CD changer.

Unfasten plug connection (3) and disconnect.

Release screws (4).

Lay retaining clip (2) slightly to one side.

IMPORTANT: Airbag module (1) could fall out after screws (5) have been released. Grip airbag module (1).

Release screws (5) and carefully remove airbag module (1).

Fig 1: Plug Connection, Retaining Clip, Airbag Module And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

When inserting airbag module (4) in channel (3), make sure channel (3) rests all round airbag module (4). If necessary, pull channel (3) apart at sides.

Replace screws (1).

Retainers (2) fall out during removal and do not have to be replaced.

For tightening torque refer to 72 12 02AZ in 72 12 AIRBAG MODULES .

Fig 2: Airbag Module, Channel, Screws, Retainers And Installation Direction

Courtesy of BMW OF NORTH AMERICA, INC.