41 00... General Cementing Instructions
WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, and 2006 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Conform with safety precautions! Refer to both Safety at work and 41 00... Information on hazards .
- The bonding surfaces must be kept free of all types of dirt and contamination. Avoid leaving fingerprints.
- Cleanliness is the golden rule for all bonds!
- Cleaning agent: Isopropanol, acetone or spirit
Expiry date of adhesive and primer
- The adhesive cartridge and the primer are marked with a date.
- Do not use the adhesive or primer after this date.
2-component adhesive application:
- Insert adhesive cartridge in adhesive gun, remove cap and allow some adhesive to emerge. Strip adhesive components uniformly and attach mixing tube.
- Allow approx. 1 mixer length of mixed adhesive to emerge (there must be no smearing of colors). Only then apply the mixed adhesive to one side of the bonding surface.
Adhesive disposal:
- Hardened adhesive is disposed of as normal waste.
- Empty adhesive cartridges are disposed of as normal waste.
- Non-hardened adhesives and mixtures of adhesive and solvent and the like must be disposed of as hazardous waste.
These regulations apply to the Federal Republic of Germany.
For other countries, comply with the (possibly differing) nationally applicable regulations.