33 33 001 Replacing Left Or Right Rear Axle Carrier Tension Strut
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions when raising the vehicle
Driving without compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front is both tension struts have to be replaced!
Driving without compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front is both tension struts have to be replaced!
Necessary preliminary tasks:
- Remove rear lip
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from tension strut. See 37 13 110 REMOVING AND INSTALLING/REPLACING PRESSURE LINE FOR OSCILLATING MOTOR/REAR AXLE .
Release screw (1).
Tightening torque 33 32 28AZ . See REAR AXLE - TIGHTENING TORQUES .
Remove heat shield (2) from clip (3) on fuel tank retaining strap.
Installation:
Check clip (3) for damage and replace if necessary.
Release screws (1).
Tightening torque 33 32 17AZ . See REAR AXLE - TIGHTENING TORQUES .
Release screw (2) and remove tension strut (3).
Secure rear axle carrier by inserting screw (2).
Installation:
Check threads for damage; if necessary, repair with Heli-coil thread inserts.
Tightening torque 33 33 3AZ . See REAR AXLE - TIGHTENING TORQUES .