32 00 620 Adjusting Rear Axle

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust camber to setpoint value.

Tighten nut (2).

Tightening torque 33 32 20AZ . See REAR AXLE - TIGHTENING TORQUES .

Fig 1: Turning Eccentric Bolt (Adjusting Camber)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting toe:

Replace nut (2) and tighten to 5 Nm.

Turn eccentric bolt (1) to adjust toe to specified value.

Tighten nut (2).

Tightening torque 33 32 5AZ . See REAR AXLE - TIGHTENING TORQUES .

Fig 2: Turning Eccentric Bolt (Adjusting Toe)

Courtesy of BMW OF NORTH AMERICA, INC.