51 45 370 Removing and installing (replacing) left decorative strip on dashboard

Special tools required:

Set steering wheel to its lowest position.

Undo and remove screws (1) from back of engine speed display (2).

Take engine speed display (2) and pull it toward the rear of the car.

Fig 1: Identifying Rev Counter And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip and remove finisher (1) from its attachment points (2) using special tool 00 9 317 .

(Shown with engine speed display removed for better clarity.)

Installation note:

Make sure bolts are correctly located on decorative strip (1).

If necessary, replace defective clips.

Fig 2: Identifying Decorative Strip And Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Pull engine speed display (1) toward the rear of the car.

Remove decorative strip (2) upwards.

Fig 3: Removing Decorative Strip

Courtesy of BMW OF NORTH AMERICA, INC.