61 35 177 Removing and installing (replacing) rain/light sensor

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE .

Unclamp cover (1) in direction of arrow and remove.

Fig 1: Unclipping Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out locks (1) in direction of arrow and remove rain/light sensor (2).

Disconnect plug connection (3).

Installation note:

Do not damage optical element covered by rain/light sensor (2).

Replacement:

Encode JBE and initialize RAIN/LIGHT SENSOR (2).

Fig 2: Removing Rain/Light Sensor

Courtesy of BMW OF NORTH AMERICA, INC.