52 26 303 Removing and installing/replacing actuator for rear seat backrest

Necessary preliminary tasks: 

• Remove BACKREST COVER .

Unclip trim (1) and feed out from release lever (2).

Installation: 

Retaining lugs must not be damaged.

If necessary, replace faulty trim (1).

Fig 1: Identifying Trim And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cable (2) out of grip recess plate (1).

Fig 2: Identifying Bowden Cable And Grip Recess Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Press in detent lugs and remove grip recess plate (1).

Fig 3: Pressing Detent Lugs

Courtesy of BMW OF NORTH AMERICA, INC.