51 24 391 Replacing the rubber buffer for the rear lid support

Top rubber buffer (R58 only): 

Unscrew rubber buffer (1).

Installation note: 

Adjust both rubber buffers (1), work is described in ADJUSTING REAR LID LOCK .

Fig 1: Identifying Rubber Buffer

Courtesy of BMW OF NORTH AMERICA, INC.

Bottom rubber buffer: 

Release screws (1) and remove holder (2).

Tightening torque 51 24 15AZ .

Installation note: 

Adjust both stop buffers (3), work is described in ADJUSTING REAR LID LOCK .

Fig 2: Identifying Stop Buffers, Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.