51 13 377 Remove, install/replace C-pillar cover

Special tools required:

00 9 325

IMPORTANT: The INSTRUCTIONS on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

Remove trim:

Heat cover (1) using a hot air blower and remove from side window (2) using special tool 00 9 325 .

Fig 1: Identifying Cover And Side Window

Courtesy of BMW OF NORTH AMERICA, INC.

Install cover:

Pull liner* off cover (1).

Affix cover (1) according to dimensions (A and B) in relation to the rear window (3) to the side window (2).

A = 4.9 ± 1 mm

B = 6.3 ± 1.8 mm

Apply thumb pressure force over entire bonding surface of cover (1).

*Liner is the protective film on adhesive tape.

Fig 2: Checking Cover Installation Dimension

Courtesy of BMW OF NORTH AMERICA, INC.