51 32 153 Adjusting front left or right side window inclination

Special tools required:

51 0 350

Requirements for correct adjustments:

FRONT DOOR CORRECTLY ADJUSTED
Car must stand on its wheels

To adjust, a special tool 51 0 350 is required.

Ideal setting, inclination (preload):

NOTE: Inclination is checked with installed weather strip. Special tool (51 0 351) creates a gap for measuring preload. No force must be exerted on the door or door window glass during measurement.

Fig 1: Identifying Special Tool (51 0 351)

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool (51 0 351) in rotary striker of door lock and press in up to end stop. Door window glass then moves fully to the top. Carefully leave door slightly open until magnet makes contact with striker.

Slide special tool (51 0 352) at distance (B) to door window glass side edge into gasket (1) and measure dimension (A) to outer edge of door window glass (2).

Dimension (A) with weather strip:

	A	B
R56, R57	36 ± 2 mm	10 mm
R58	30 ± 2 mm	80 mm

Fig 2: Measuring Dimension To Outside Edge Of Door Window Glass Using Special Tool (51 0 352)

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting inclination (preload):

Lever out caps (1).

Slacken screws (2)

Adjust inclination by shifting window lift rail (3).

Check adjustment. If necessary, repeat procedure.

Fig 3: Adjusting Inclination Of Window Lift Rail

Courtesy of BMW OF NORTH AMERICA, INC.

Special tools required:

51 0 350

Requirements for correct adjustments:

FRONT DOOR CORRECTLY ADJUSTED
Car must stand on its wheels

To adjust, a special tool 51 0 350 is required.

Ideal setting, inclination (preload):

NOTE: Inclination is checked with installed weather strip. Special tool (51 0 351) creates a gap for measuring pre-tension. No force must be exerted on the door or door window glass during measurement.

Fig 1: Identifying Special Tool (51 0 351)

Courtesy of BMW OF NORTH AMERICA, INC.

Mount special tool (51 0 352) at the height of the locking button on gasket (1) and measure dimension (A) to outer edge of door window pane (2).

Dimension (A) = 11 ± 1 mm

Fig 2: Measuring Dimension To Outer Edge Of Door Window Pane

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting inclination (preload):

Lever out caps (1).

Slacken screws (2)

Adjust inclination by shifting window lift rail (3).

Check adjustment. If necessary, repeat procedure.

Fig 3: Adjusting Inclination Of Window Lift Rail

Courtesy of BMW OF NORTH AMERICA, INC.