37 10 005 Removing and Installing/Replacing Vent Hose (From 06/2003) For Active Stabilizer (Front)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front assembly underside protection See 51 47 490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION
Release banjo bolts (2) and remove vent hose (3).
Tightening torque 37 11 2AZ . See 37 11 CONTROL AND SUSPENSION ELEMENTS, FRONT
Disconnect vent hose (3) from Y-distributor.
Unscrew vent valves (1) from oscillating motor.
Installation:
If necessary, fit new vent valves (see note at end of document).
Tightening torque 37 11 1AZ . See 37 11 CONTROL AND SUSPENSION ELEMENTS, FRONT
Unclip cover (1) and pull filter out of front axle carrier.
Expose vent hose (2) up to Y-distributor and remove.
Replacing vent valve:
Screw vent valve (1) fully into oscillating motor and remove plug.
Slide vent hose (2) into vent valve (1) up to second marking (M).