41 61 000 Hood Lid Removal And Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove and install both gas-filled struts for engine hood . See 51 23 265 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT GAS STRUT FOR ENGINE BONNET/HOOD .
The following illustration serves as a general guide and is to be applied to the relevant vehicle type.
Release screw (1).
Loosen screw (2).
Remove hood lid.
Installation:
Install engine hood at screw locations on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, adjust engine hood . See 41 61 014 ADJUSTING HOOD LID .