41 34 041 Tail Panel Complete Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Read contents of Body, General . See 41 0 CONTENTS OF BODY, GENERAL .

Spot-weld bonding is used for the first time on the E65. A specific procedure must be followed here.

Following new body parts are required:

(1) Rear trim, complete
(2) End panel, rear lights base, left and right

Fig 1: Identifying Rear Trim, Complete And End Panel, Rear Lights Base, Left And Right
Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Open brazed joints in areas (2).

Fig 2: Identifying Weld Joints Area And Brazed Joints Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1) on inside of luggage compartment on left and right.

Remove plate (2) and tail panel.

Fig 3: Identifying Weld Joints Areas And Plate

Courtesy of BMW OF NORTH AMERICA, INC.