11 00 670 Securing Engine In Installation Position (N62, N62TU)
Special tools required:
Danger of injury!
- Prior to each use, check the special tools for defects, modifications and operational reliability.
- Damaged/modified special tools must not be used!
- No changes or modifications may be made to the special tools!
- Keep special tools dry, clean and free of grease.
Observe following instructions relating to special tool:
Necessary preliminary tasks:
- Secure 5100 ENGINE BONNET/HOOD IN SERVICE POSITION (5-SERIES) , 51 00 ... SERVICE POSITION OF ENGINE HOOD/BONNET (6-SERIES) or 51 00 ... SERVICE POSITION OF ENGINE HOOD/BONNET (7-SERIES)
- Remove ACOUSTIC COVER
- Remove 13 71 000 INTAKE FILTER HOUSING
- Detach 17 11 100 COOLANT EXPANSION TANK (5-SERIES shown; others similiar) , and place to one side
- Remove tension strut (on spring strut dome)
Assemble transverse member 00 0 200 with special tools 00 0 202, 00 0 204, 00 0 208.
Avoid a change of engine position in the transversal or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.
Risk of damage!
Position transverse member 00 0 200 with a 2nd person helping by way of rests (1) on bolt connections of side panels.
Secure special tool 11 0 000 to spindle 00 0 202.
Attach suitable chains to special tool 11 0 000 and suspend from both engine suspension eyes.
Danger of injury!
Tighten down all adjusting screws and nuts on transverse member 00 0 200.
Unscrew nuts (1).
Raise engine approx. 10 mm with transverse member.
Installation:
Replace self-locking nuts.
Tightening torque: 22 11 2AZ . See ENGINE SUSPENSION for specs.