12 14 521 Replacing crankshaft pulse sensor (N14, N16, N18)

Necessary preliminary work:

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

Remove cover (1).

Fig 1: Identifying Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screw and remove pulse sensor.

Tightening torque 13 62 3AZ .

Fig 2: Identifying Pulse Sensor, Connector, And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Delete fault memory.