51 13 085 Removing and installing/replacing trim strip on engine hood/bonnet (cowl panel)
IMPORTANT:
Risk of damage!
Do not bend trim strip (1) and chrome strip (2) during removal.
Do not bend trim strip (1) and chrome strip (2) during removal.
Carefully detach trim strip (1) in direction of arrow from hood/bonnet.
NOTE:
To remove, if necessary tape off hood/bonnet with adhesive tape and remove trim strip (1) with a suitable tool.
Installation note:
Make sure chrome strip (2) is correctly seated on trim strip (1), reinstall chrome strip (2) if necessary.
Pay attention to center marking on trim strip (1) and hood/bonnet.