51 43 002 Removing and installing/replacing rear left or right side trim panel

Necessary preliminary tasks:

Unclamp cover (1) and remove.

Release screw (2) on end fitting.

Tightening torque 72 11 4AZ .

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on seat belt deflection.

Tightening torque 72 11 3AZ .

Fig 2: Identifying Screw On Seat Belt Deflection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and guide cover (2) over seat belt (3).

Tightening torque 72 11 17AZ .

Fig 3: Releasing Screws And Guide Cover Over Seat Belt

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) and feed out cover (2) from seat belt (3).

Fig 4: Removing Cover From Seat Belt

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip trim panel (1) from clamps (2) at top on the respective side only.

Installation note:

Replace faulty clamps (2).

Fig 5: Removing Trim Panel From Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out seal (1) from clip (2) and release screw underneath.

Release expanding rivet (3).

Release screws (4).

Tightening torque 51 43 4AZ .

Release side trim panel at clips (5) and feed out.

Installation note:

Replace faulty retaining elements.

Ensure seal (1) is correctly seated.

Fig 6: Identifying Seal, Clips, Expanding Rivet, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.