51 11 050 Removing and installing/replacing support for front bumper panel

Special tools required:

00 2 270

Necessary preliminary tasks:

Remove FRONT BUMPER PANEL

To perform this task, special tool 00 2 271 from special tool set 00 2 270 is needed.

NOTE: The operation is described on the right side; proceed in the same way for the left side.
The position of the front panel is not altered by special tool (00 2 271). Therefore no adjustment work is required.

Remove foam part from support.

Insert special tool (00 2 271) and screw down.

If necessary, release cable holder (1).

Release screws (2 and 4).

Release nuts (3) and remove carrier.

Fig 1: Identifying Special Tool (00 2 271), Nuts, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure foam part is correctly positioned on support.

Tightening torque 51 11 3AZ .