41 00... Use Of Materials In Outer Shell
WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
The following illustration is a schematic representation of all the body variants.
Apply this illustration to the relevant vehicle.
All components not listed in the table below are composed of established sheet steel qualities.
MATERIAL REFERENCE CHART
| Component | Vehicle | Material |
|---|---|---|
| (1) Side panel, front | E52 (Z8) | Aluminum |
| E60, E61 | Aluminum | |
| E63, E64 | Plastic (thermoplastic) | |
| E65, E66: | Aluminum | |
| E70, E92, E93 | Plastic (thermoplastic) | |
| (2) Front door | E36/C (M3) | Aluminum or steel |
| E36/2 (M3) | Aluminum or steel | |
| E52 (Z8) | Aluminum | |
| E63, E64 | Aluminum | |
| (4) Side panel, rear | E52 (Z8) | Aluminum |
| (5) Engine hood | E38 (750i) | Aluminum or steel |
| E46/C (M3) | Aluminum | |
| E46/2 (M3) | Aluminum | |
| E52 (Z8) | Aluminum | |
| E60, E61, E63, E64 | Aluminum | |
| E65, E66, E70 | Aluminum | |
| E85 (Z4) | Aluminum | |
| (6) Hardtop/roof | E36/C | Aluminum |
| E36/7 (Z3) | Plastic (glass fibre / epoxy resin) | |
| E46/C | Aluminum | |
| E46/2 (M3 CSL) | Plastic (CFK) | |
| E52 (Z8) | Plastic (PU) | |
| E85 (Z4) | Plastic (SMC) | |
| E63 (M6) | Plastic (CFK) | |
| (7) Soft top lid | E46/C | Magnesium |
| E64 | Plastic (SMC) | |
| (8) Rear lid | E46/2 (M3 CSL) | Plastic (SMC) |
| E52 (Z8) | Aluminum | |
| E63, E64 | Plastic (SMC) |