51 14 110 Removing and installing/replacing rear model designation
IMPORTANT:
The INSTRUCTIONS FOR ADHERING BADGE EMBLEM serve as the basis for these repair instructions and must be followed without fail.
Installation dimensions:
Mark position of model designation with adhesive tape using dimensions (A and B).
Position model designation on mark and stick on.
| A | B | |
| One | 238 mm | 46 mm |
| One D | 238 mm | 72 mm |
| Cooper | 238 mm | 32 mm |
| Cooper S | 238 mm | 44 mm |
| Cooper D | 238 mm | 52 mm |
| Cooper SD | 238 mm | 48 mm |