61 62 060 Removing and installing/replacing rear wiper motor

Necessary preliminary tasks: 

• Remove WIPER ARM FOR REAR WIPER 
• Remove TRIM FOR TAILGATE AT BOTTOM

Pull off hose (1).

Disconnect plug connection (2).

Release screws (3). Tightening torque 61 62 2AZ .

Pull rear wiper motor out of rear window grommet.

Installation note: 

Check grommet of wiper pivot for signs of damage, replace if necessary.

Adjust WASHER JET .

Fig 1: Identifying Rear Wiper Motor Hose, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.