65 83 590 Removing and installing/replacing gyro sensor drive for Car Communication Computer

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

If necessary, cut through warranty seal.

Release screws (1).

Remove floor pan (2) towards bottom and set down.

IMPORTANT: Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!

When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.

Fig 1: Identifying Screws, Spring Strip And Floor Pan

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).

Fig 2: Removing Gyro Sensor From Plug-In Contact

Courtesy of BMW OF NORTH AMERICA, INC.