LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2011 >> Cooper Works Clubman >> Repair and Diagnosis >> External Pages >> Different car >> Section 760 (Heating And Air Conditioning - Repair - Cooper (R50) , Cooper S (R53) & Convertible (R52)) >> Air Conditioning System >> 64 50 ... Leak-testing with leak tester device

64 50 ... Leak-testing with leak tester device

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Avoid contact with refrigerant. Follow safety precautions when handling refrigerant. Refer to 64 50 ... SAFETY INSTRUCTIONS FOR HANDLING REFRIGERANT R 134A 

Carry out leak-testing with a leak tester device from the workshop equipment catalog following the device manufacturer's operating instructions.

If leaks not to be localized are already identified during evacuation, the A/C system must nevertheless be filled. Refer to 64 50 009 DRAWING OFF, EVACUATING AND FILLING A/C SYSTEM (R 134A) . Then test for leaks with leak tester device.

NOTE:

Refrigerant is heavier than air.

Therefore always conduct the leak test below the lines and components to be tested.

Shield lines and components against strong blasts of air (wind, drawing off).

Tighten down loose lines, mark leaks.

Then draw off draw off A/C system and seal off or repair leakage points. Refer to 64 50 009 DRAWING OFF, EVACUATING AND FILLING A/C SYSTEM (R 134A) .

Then refill A/C system and test for leaks. Refer to 64 50 009 DRAWING OFF, EVACUATING AND FILLING A/C SYSTEM (R 134A) .