24 10 018 Adjusting selector lever (AISIN)
IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in gear tooth meshing noises being transmitted to the passenger compartment.
Adjust SELECTOR LEVER if necessary.
Necessary preliminary work:
- Remove air intake silencer housing. See 13 71 000 REMOVING AND INSTALLING THE INTAKE SILENCER HOUSING (N16) or 13 71 000 REMOVING AND INSTALLING/REPLACING THE INTAKE SILENCER HOUSING (N14, N18) .
- Remove intake silencer housing gaiter.
- Move selector lever into "P" position.
Insert the end of the gear selector cable into the locating sleeve (1) of selector lever.
Insert gear selector cable in holder.
Secure gear selector cable with clip to retaining bracket (2).
Move selector lever to "P" position (in counter-clockwise direction).
Grip nut (1) and tighten down nut (2).
NOTE:
Press against end of gear selector cable shortly before tightening down screw.
Tightening torque 24 11 8AZ .
NOTE:
Graphic similar.