11 51 000 Removing and installing/replacing coolant pump (N16)
WARNING:
Risk of scalding!
Only perform these tasks on an engine that has cooled down.
Only perform these tasks on an engine that has cooled down.
Recycling:
Catch and dispose of drained coolant.
Observe country-specific waste disposal regulations.
Installation note:
- All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
- Retaining elements on chassis and suspension and steering parts must be replaced.
Necessary preliminary tasks:
- Remove FRICTION GEAR .
Release screws (1).
Remove coolant pump (2) downwards.
Installation note:
Replace gasket.
Clean sealing surfaces.
Assemble engine.
Bleeding instructions must be observed. See VENT COOLING SYSTEM AND CHECK ON WATERTIGHTNESS or BLEED AND FILL COOLING SYSTEM WITH VACUUM FILLING UNIT .