13 54 020 Removing and installing/sealing right throttle valve assembly (N63)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Turn off ignition
Remove right INTERCOOLER

NOTE: Picture shows the left throttle valve assembly, the procedure for the right side is identical.

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Installation:

Check plug connection (1) for coolant remnants. If necessary, clean plug connection (1) with compressed air.

Fig 1: Identifying Throttle Valve Assembly And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Throttle Body Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault message.

clear fault memory.