33 32 076 Removing and installing/replacing top left and right wishbone
NOTE:
If the wishbone is detached from the rear axle support, it is necessary after reinstallation to carry out a chassis/wheel alignment check. See CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION
or WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD
.
Necessary preliminary work:
- Remove VEHICLE UNDERBODY COVER on left (or right).
Only on right with ride height sensor:
Unscrew nut (3).
Installation note:
Tightening torque 37 14 4AZ .
Release nut and remove screw (1).
Tightening torque 33 32 3AZ .
Installation note:
Replace self-locking nut.
Tighten down screw connection in NORMAL POSITION .
Release nut and remove screw (2).
Tightening torque 33 32 1AZ .
Take off wishbone.
Installation note:
Replace self-locking nut.
Tighten down screw connection in NORMAL POSITION .
Replacement:
- Modify stop pad (1).
After Installation note:
- Perform wheel alignment check. See CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .