65 90 510 Removing and installing/replacing navigation computer with CD-drive

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For Special Tool identification, see AUDIO, NAVIGATION AND ANTI-THEFT - TIGHTENING TORQUES - COOPER (1.6L) R50/W10 .

Special Tools Required:

65 5 400

Necessary Preliminary Tasks:

Comply with notes and instructions on handling navigation computers. Refer to 65 90 ... NOTES ON HANDLING NAVIGATION COMPUTERS .
Remove right front seat. Refer to 52 13 000 REMOVING AND INSTALLING DRIVER'S OR FRONT PASSENGER SEAT (NORMAL / MANUAL) .
If necessary, remove rear right foot mat.

Unfasten screws (1 and 2).

Lift housing (3) out of air duct (5) and floor carpet.

Installation:

Insert tab (4) below air duct (5).

Fig 1: Locating Tab On Housing

G03307269

Courtesy of BMW OF NORTH AMERICA, INC.

Open flap (1).

Release screws (2) and move cover (3) forwards.

Fig 2: Opening Flap Of Housing

G03307270

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1).

Remove navigation computer (2) complete with cover (5).

Replacement only:

Release nuts (3).

Remove navigation computer (2) with holder (4) from cover (5).

Fig 3: Removing Navigation Computer With Cover

G03307271

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit cable grommet (1) correctly in housing (2).

Fig 4: View Of Cable Grommet In Housing

G03307272

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Unlock navigation computer (1) with special tool 65 5 400 and pull out of holder (2).

Fig 5: Removing Navigation Computer

G03307273

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Carry out coding/programming.

Fig 6: Identifying Programming Equipment

G03307274

Courtesy of BMW OF NORTH AMERICA, INC.