41 34 060 Stripping operations - Replacing outer and inner tail panel sections
NOTE:
Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.
The following list basically represents the removal sequence.
- Disconnect negative battery cable (job number: 61 20 900)
- Remove bumper trim (job number: 51 12 156)
- Remove bumper support (job number: 51 12 050)
- Remove left and right holder for bumper (job number: 51 12 801)
- Remove guide for bumper at rear center (job number: 51 12 825)
- Remove cover on tail panel at top (FR number: 51 46 050)
- Remove luggage compartment floor trim panel (FR number: 51 47 101)
- Remove and install left and right luggage compartment wheel arch panels (FR number: 51 47 151)
- Remove tailgate lock (job number: 51 24 100)
- Remove left and right tail lights (job number: 63 21 170)
- Completely remove exhaust system (job number: 18 00 020)
- Remove rear heat shield
- Partially detach tailgate seal
- Partially release wiring harness