41 61 014 Adjusting Engine Compartment Lid: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, 2012 BMW 760Li, and 2011 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The BATTERY EARTH LEAD must be clamped off on vehicles with AFGS active pedestrian protection!
Do not damage adjoining body components!
Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

NOTE: Observe 41 00... BODY GAP DIMENSIONS .

NOTE: Stop screw must not be damaged or missing. If necessary, replace engine compartment lid hinge.

The stop screw is preset and must not be used to adjust the engine compartment lid!

Fig 1: Identifying Engine Compartment Lid Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nuts (1) of hinges on left and right.

Engine compartment lid must be able to be moved.

Tightening torque: see 1AZ in 41 61 ENGINE COMPARTMENT LID .

NOTE: If adjustment range is not sufficient, slacken screws on body and slide hinge. (Refer to HEIGHT ADJUSTMENT AT HINGE )

Fig 2: Identifying Nuts Of Hinges On Left And Right

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust engine compartment lid sideways and lengthways.

Strikers must snap into place in the locks.

Fig 3: Identifying Strikers Snap Position

Courtesy of BMW OF NORTH AMERICA, INC.